THERMAL LAB · RP-05 · RESEARCH PROGRAMS

Program: heating elements

Flexible heating elements now come in many forms, and their data sheets are not comparable. This program tests them on one rig, under one set of conditions, so that a choice rests on measurement. Stage: bench.

In this section
  1. RP-01 Program: the wearable microclimate
  2. RP-03 Program: heat-reflective surfaces
  3. RP-04 Program: thin insulation
  4. RP-05 Program: heating elements
  5. RP-08 Program: personal cooling
  6. RP-09 Program: comfort for cold-sensitive people

The question

For a thin, flexible heater inside a layered system, which element technology gives the most even heat, the most predictable ceiling and the best use of a limited battery?

Classes we evaluate

ClassHow it makes heatWhat we watch
Carbon fiber and carbon fabricCurrent through conductive fibersEvenness, connection points
Printed carbon and graphene filmsCurrent through a printed conductive layerEvenness, durability when flexed
Etched or printed metal tracesCurrent through a patterned trackHot lines between cool gaps
Self-regulating PTCResistance rises with temperatureCeiling temperature, inrush current

What a data sheet leaves out

A sheet usually gives resistance, voltage and a single surface temperature. It rarely says where on the element that temperature was measured, in what surroundings, or how long it took to reach. Two elements rated the same can differ by many degrees between center and edge.

Our comparison

Each element is run at the same electrical input, in the same layer stack, with the same sensors in the same positions.

  • Warm-up curve from a cold start.
  • Thermal image at steady state, with the spread between hottest and coolest regions.
  • Energy drawn per hour to hold a target temperature.
  • Behavior when covered, folded or partly insulated.
  • Repeat runs to confirm the result.

What we look for

The best element for this architecture is not the hottest. It is the one that puts the most even warmth into the air gap for each watt-hour and settles at a predictable temperature without help. An element that needs its control electronics to rescue it from a hot spot is a liability.

The reasoning is in control and limits. Material background is in resistive heating films and PTC materials.

Put the lab to work.

Send a brief. A mutual nondisclosure agreement comes first.

Start a program