THERMAL LAB · MA-05 · MATERIALS

PTC self-regulating materials

A PTC material raises its electrical resistance sharply as it reaches a set temperature. As resistance rises, current and heat fall. The element finds its own ceiling and holds it, with no sensor and no switch.

In this section
  1. MA-01 Heat-reflective films and fabrics
  2. MA-02 Aerogel and foam insulation
  3. MA-03 Heat spreaders
  4. MA-04 Resistive heating films and fabrics
  5. MA-05 PTC self-regulating materials
  6. MA-06 Phase change materials
  7. MA-07 Air-activated warmers
  8. MA-08 Textiles and carriers
  9. MA-09 Lithium cells in the cold

How it works

PTC stands for positive temperature coefficient. In a polymer PTC, conductive carbon particles are dispersed in a plastic. When cool, the particles touch and current flows. As the plastic warms and expands, the particles separate and resistance climbs steeply. Ceramic PTC materials reach a similar result by a change in their crystal structure.

What it gives a designer

  • A ceiling set by the material. It cannot be misconfigured.
  • Local response. Each part of the element regulates itself. A covered region reduces its own power while the rest carries on.
  • Automatic adjustment. In cold surroundings the element draws more power. As it warms it draws less.
  • Simple control. A basic on and off switch is enough for many uses.

What it costs

PropertyConsequence
High power when coldA large starting current. The supply and wiring have to allow for it.
Fixed switching temperatureChanging the ceiling means changing the material.
Gradual transitionThe ceiling is a zone and not a sharp line. It depends on how well heat is carried away.
AgingSome polymer PTC materials drift over many cycles.

The ceiling depends on surroundings

A PTC element settles where the heat it makes equals the heat it loses. In open air it holds one surface temperature. Covered with insulation it settles a little higher and draws much less power. The figure on a data sheet applies to one condition. It should be measured in the actual stack.

PTC and control together

Inherent regulation and electronic control combine well. The material provides the ceiling. Electronics provide adjustable levels below it. If the electronics fail, the material limit remains. That is the arrangement we favor. See control and limits.

Testing a PTC element

  • Starting current from cold.
  • Settled temperature in open air and in the stack.
  • Settled power in each.
  • Response when part of the element is covered.
  • Repeat after many cycles.

Knowledge background: PTC self-regulating heaters.

Put the lab to work.

Send a brief. A mutual nondisclosure agreement comes first.

Start a program