THERMAL LAB · MA-06 · MATERIALS

Phase change materials

A phase change material stores heat by melting and gives it back by freezing, and it does both at a nearly constant temperature. That makes it a buffer. It soaks up a surplus and covers a shortfall while holding a set point.

In this section
  1. MA-01 Heat-reflective films and fabrics
  2. MA-02 Aerogel and foam insulation
  3. MA-03 Heat spreaders
  4. MA-04 Resistive heating films and fabrics
  5. MA-05 PTC self-regulating materials
  6. MA-06 Phase change materials
  7. MA-07 Air-activated warmers
  8. MA-08 Textiles and carriers
  9. MA-09 Lithium cells in the cold

Latent heat

Warming a material raises its temperature. Melting it does not. During melting, energy goes into changing the structure and the temperature stays at the melting point. That energy, the latent heat, comes back when the material solidifies.

MaterialMelting pointLatent heat
Water ice0 °C (32 °F)About 334 kJ/kg, or 93 Wh/kg
Paraffin waxesSelectable, roughly 5 to 80 °C (41 to 176 °F)About 150 to 250 kJ/kg, or 42 to 69 Wh/kg
Salt hydratesSelectableSimilar per kg, denser, can separate over cycles
Bio-based fatty acids and estersSelectableAbout 150 to 220 kJ/kg

Choosing the melting point

The melting point is the design parameter. For cooling a person, a material that melts in the high teens to mid 20s °C (mid 60s to high 70s °F) feels cool without the shock of ice and does not sweat with condensation. For holding warmth, a material that solidifies in the 30s to 40s °C (high 80s to low 100s °F) releases heat at a comfortable temperature.

How much is enough

The figures set firm limits. A kilogram of paraffin PCM stores roughly 50 Wh as latent heat. A person at rest produces about 100 W. A PCM pack is therefore a buffer for a period, sized in tens of minutes to a few hours depending on mass and load. It is not a substitute for a continuous source or a continuous sink.

Forms

  • Sealed packs of bulk material. Highest capacity per volume, rigid when frozen.
  • Microencapsulated PCM in fabrics and foams. Pleasant to wear, with a small capacity that evens out brief swings.
  • Shape-stabilized sheets in which PCM is held in a polymer or graphite matrix and stays solid to the touch.

Limits

  • PCMs conduct heat poorly, so thick packs charge and discharge slowly unless a conductive filler or thin geometry is used.
  • Paraffins are flammable and need sound encapsulation.
  • A PCM must be recharged, by cooling or heating it back through its melting point.

Uses in thermal architecture

Smoothing the cycling of a heater. Extending warmth after a source is exhausted. Absorbing body heat under clothing that blocks evaporation. Holding a payload within a temperature band in transit.

Knowledge background: phase change material clothing and phase change cooling vests.

Put the lab to work.

Send a brief. A mutual nondisclosure agreement comes first.

Start a program