THERMAL LAB · MA-02 · MATERIALS

Aerogel and foam insulation

Insulation works by holding gas still. The smaller the pockets of gas, the less heat gets across. Aerogels take that to its limit, and foams offer a practical middle ground.

In this section
  1. MA-01 Heat-reflective films and fabrics
  2. MA-02 Aerogel and foam insulation
  3. MA-03 Heat spreaders
  4. MA-04 Resistive heating films and fabrics
  5. MA-05 PTC self-regulating materials
  6. MA-06 Phase change materials
  7. MA-07 Air-activated warmers
  8. MA-08 Textiles and carriers
  9. MA-09 Lithium cells in the cold

Thermal conductivity

Insulation is rated by thermal conductivity, in W/m·K. Lower is better. Resistance to heat flow is thickness divided by conductivity, so a material with half the conductivity does the same job at half the thickness.

MaterialTypical conductivity, W/m·K
Silica aerogel composites0.013 to 0.020
Still airAbout 0.026
Closed-cell polymer foams0.030 to 0.040
Fleece and fibrous battings0.035 to 0.050
Solid polymers0.2 to 0.4

Aerogels beat still air because their pores are smaller than the distance air molecules travel between collisions, which suppresses conduction through the gas.

Aerogel in practice

Pure silica aerogel is brittle and dusty. Usable products embed aerogel particles in a foam, a fiber mat or a coating. The composite is flexible and handles well, and its conductivity is higher than the pure material because the binder conducts.

Strengths: best performance per millimeter, wide temperature range. Weaknesses: cost, variable particle distribution, dust from some products, limited stretch.

Closed-cell foams

Polyethylene, EVA and similar foams trap gas in sealed cells. They are consistent, inexpensive, washable and available everywhere. They compress under load and recover, which makes them comfortable and costs some performance while squeezed.

Air-gap structures

A spacer fabric or a dimpled layer holds two surfaces apart with mostly air between. The insulation is the air. Such structures breathe and weigh very little. They rely on the air staying still, so they work best in enclosed positions.

What to check

  • Conductivity at the thickness you will actually use.
  • Thickness and conductivity under the compression the product will see.
  • Whether perforations or stitching create paths for heat.
  • Behavior at the temperature of the hot face.
  • Lot to lot consistency.

Choosing

For a layer a few millimeters thick, the gap between a good foam and an aerogel composite is real and modest. Consistency, compression behavior and supply often decide the matter. See the program on thin insulation and the Knowledge article on aerogel clothing insulation.

Put the lab to work.

Send a brief. A mutual nondisclosure agreement comes first.

Start a program