THERMAL LAB · MA-07 · MATERIALS

Air-activated warmers

An air-activated warmer makes heat by rusting iron powder at a controlled rate. It has no electronics, weighs little, lasts for hours and limits itself by the air it can reach. For many uses it is a better heat source than a battery.

In this section
  1. MA-01 Heat-reflective films and fabrics
  2. MA-02 Aerogel and foam insulation
  3. MA-03 Heat spreaders
  4. MA-04 Resistive heating films and fabrics
  5. MA-05 PTC self-regulating materials
  6. MA-06 Phase change materials
  7. MA-07 Air-activated warmers
  8. MA-08 Textiles and carriers
  9. MA-09 Lithium cells in the cold

The chemistry

The pouch contains iron powder, water, salt, activated carbon and an absorbent such as vermiculite. When the outer wrapper is opened, oxygen passes through the porous pouch and the iron oxidizes. The reaction releases heat. Salt speeds it. Carbon spreads the heat and holds moisture. The absorbent keeps the mix from caking.

What controls the output

Oxygen supply. The pouch material sets how fast air reaches the iron. More air means more heat and a shorter life. Less air means cooler and longer.

This is why warmers are designed for a location. A hand warmer expects the still air of a pocket. A toe warmer expects the very limited air inside a boot and is formulated to work with less. Used in open air, a toe warmer runs hot and short.

Typical behavior

PhaseWhat happens
ActivationSeveral minutes to reach working temperature
PlateauHours of fairly steady output
DeclineOutput falls as the iron is used up

Duration and temperature printed on the package refer to the maker's test conditions. In a different enclosure the result differs. We measure warmers in the actual pocket.

Strengths

  • No battery, no charging, no electronics.
  • High energy for the weight.
  • Unaffected by cold storage.
  • Self-limiting by oxygen supply.
  • Inexpensive and sold everywhere.

Limits

  • Single use.
  • Output cannot be adjusted once running, except by restricting air.
  • Warmers can exceed comfortable skin temperatures and are not meant for direct contact with skin.
  • They need some air. In a sealed space they stop.

In a thermal architecture

A warmer is a small, fairly hot, self-limiting source. The architecture's job is to turn that into broad, gentle warmth. In HEATJAC CORE the warmer sits outermost in the pocket, with insulation and a heat-reflective layer between it and the body, and warms the air under the outer garment. The pocket material lets air reach it.

Knowledge background: how hand warmers work and how long hand warmers last.

Put the lab to work.

Send a brief. A mutual nondisclosure agreement comes first.

Start a program