THERMAL LAB · MA-03 · MATERIALS

Heat spreaders

A heat spreader is a thin layer that conducts heat sideways far better than the materials around it. It takes heat from a small hot region and delivers it over a larger area at a lower, more even temperature.

In this section
  1. MA-01 Heat-reflective films and fabrics
  2. MA-02 Aerogel and foam insulation
  3. MA-03 Heat spreaders
  4. MA-04 Resistive heating films and fabrics
  5. MA-05 PTC self-regulating materials
  6. MA-06 Phase change materials
  7. MA-07 Air-activated warmers
  8. MA-08 Textiles and carriers
  9. MA-09 Lithium cells in the cold

Why spread heat

Many heat sources are small or uneven. A compact heater is hottest at its center. A heating trace is a hot line between cooler gaps. Left alone, the hot region limits how hard the source can be run. A spreader behind or in front of the source evens it out and lets the whole area contribute.

Electronics use the same idea. The graphite sheet behind a phone display exists to stop one chip creating a hot patch on the glass.

Materials

MaterialIn-plane conductivity, W/m·KNotes
Aluminum foilAbout 200 to 240Cheap, fatigues when flexed repeatedly
Copper foilAbout 400Heavier, costlier
Natural graphite sheetAbout 200 to 500Flexible, soft, lightweight
Synthetic pyrolytic graphite sheetAbout 700 to 1,900Very thin, very high performance, fragile

Graphite sheets are strongly directional. They conduct extremely well along the sheet and poorly through it. For spreading, that is the desired behavior.

What decides performance

Spreading ability depends on conductivity multiplied by thickness. A very thin sheet of excellent material can be matched by a thicker sheet of ordinary material. The choice is then about weight, flexibility and durability.

Contact matters as much. A spreader held loosely against a source picks up little heat. Thin adhesive layers or light, even pressure make the difference.

Trade-offs

  • Flexibility and fatigue. Metal foils crack after repeated flexing. Graphite tolerates bending and does not stretch.
  • Electrical conductivity. All of these conduct electricity and need insulating from heating circuits.
  • Emissivity. Bare metal foil has low emissivity. Graphite is high. That changes how the spreader's own surface radiates.
  • Cost. Synthetic graphite is expensive per area.

Air as a spreader

An enclosed air gap also evens out temperature, slowly, by letting warm air mix. It weighs nothing and costs nothing. In a wearable, the space under the outer garment does part of the spreading on its own, which is one reason to heat the air and not the skin.

Measurement of the result is covered in temperature uniformity.

Put the lab to work.

Send a brief. A mutual nondisclosure agreement comes first.

Start a program