THERMAL LAB · MA-04 · MATERIALS

Resistive heating films and fabrics

A resistive heater turns electrical energy into heat by passing current through a conductor. Every watt drawn becomes a watt of heat. The differences between heater types lie in where that heat appears and how the element behaves as it warms.

In this section
  1. MA-01 Heat-reflective films and fabrics
  2. MA-02 Aerogel and foam insulation
  3. MA-03 Heat spreaders
  4. MA-04 Resistive heating films and fabrics
  5. MA-05 PTC self-regulating materials
  6. MA-06 Phase change materials
  7. MA-07 Air-activated warmers
  8. MA-08 Textiles and carriers
  9. MA-09 Lithium cells in the cold

The basic relation

Power equals voltage squared divided by resistance. A 12 V supply across a 14.4 ohm element gives 10 W. Halve the resistance and the power doubles. Element design is largely the business of setting resistance and distributing it evenly over an area.

Types

TypeConstructionCharacter
Carbon fiber tow or fabricBundles of carbon fiber stitched or woven into a carrierFlexible, washable when well made, heat follows the fiber path
Printed carbon inkCarbon-loaded ink printed on film between conductive bus barsEven area heating, thin, sensitive to creasing
Graphene filmGraphene-based coating on filmThin, even, fast warm-up
Etched metal foilA metal track etched into a pattern on polymer filmPrecise resistance, heat concentrated on the track
Conductive yarnMetal-coated or carbon yarns knitted into fabricTextile feel, harder to hold to a tight resistance

What to compare

  • Evenness across the active area, seen in a thermal image.
  • Resistance change with temperature. Metals rise in resistance as they warm. Carbon changes little or falls slightly.
  • Flex life. How many bends before resistance shifts or a hot spot appears.
  • Connections. Most failures happen where the wire meets the element.
  • Thickness and hand. Whether the wearer can feel it.

Hot spots

A fold, a crack or a damaged region raises local resistance in a series path or concentrates current in a parallel one. Either way a small region can run much hotter than the rest. A plain resistive element has no awareness of this. Protection has to come from a sensor in the right place, a thermal cutoff or a self-regulating material.

Far infrared claims

Carbon and graphene heaters are often marketed for far infrared output. Every warm surface emits infrared according to its temperature and emissivity. A carbon film at 45 °C (113 °F) radiates about the same as any other high-emissivity surface at 45 °C (113 °F). See the Knowledge article on far infrared clothing.

Voltage

Lower voltage needs more current for the same power, which means thicker wires and more loss in connectors. See the Knowledge article 7 V vs 12 V heated gear.

Related: PTC materials and the program on heating elements.

Put the lab to work.

Send a brief. A mutual nondisclosure agreement comes first.

Start a program