THERMAL LAB · TA-09 · THERMAL ARCHITECTURE

Control and limits

Any system that makes heat needs something that stops it. We count the limit as part of the architecture and not as an accessory, and we prefer limits that come from the physics of the element over limits that depend on software alone.

In this section
  1. TA-01 What is thermal architecture?
  2. TA-02 The microclimate: the air you wear
  3. TA-03 Heat off the skin
  4. TA-04 The five jobs of a thermal system
  5. TA-05 The heat budget
  6. TA-06 Layer order
  7. TA-07 Zones and placement
  8. TA-08 Passive first
  9. TA-09 Control and limits
  10. TA-10 Power architecture
  11. TA-11 An architecture, not a garment
  12. TA-12 Cooling is the same problem, reversed
  13. TA-13 The HEATJAC design rules

Three layers of control

LayerHow it worksWhat it is good for
InherentThe heat source limits itself by its chemistry or its materialHolding a ceiling with nothing to fail
LocalA sensor at the element switches power on and offHolding a set temperature closely
SupervisoryElectronics watch sensors, power and timeSettings, display, battery care, fault handling

Inherent limits

An air-activated warmer is limited by how fast oxygen reaches it. A self-regulating heating element raises its own electrical resistance as it warms, so its power falls as temperature rises and it settles at a ceiling set by the material. Neither needs a working sensor to stay within bounds. See PTC materials.

Sensing where it matters

A temperature reading is only as good as the sensor's position. A sensor at the electronics reports the electronics. A sensor on the element reports the element. Neither reports the skin or the air gap unless it is placed there. In testing we log several points at once for this reason, and in design we decide what each sensor is actually protecting.

Limits that fit the location

A surface near skin needs a low ceiling. The outer face of an element that points into an air gap can run warmer, because nothing touches it. One fixed number for a whole product is either too cautious to be useful or too generous to be sound. We set limits per position.

What the user sees

Good control is quiet. The wearer should not have to think about it. Where there is something to report, a plain reading is better than a colored light.

Methods for verifying control are in steady state and stability.

Put the lab to work.

Send a brief. A mutual nondisclosure agreement comes first.

Start a program