THERMAL LAB · TA-08 · THERMAL ARCHITECTURE

Passive first

Our first design rule is passive first. Before any heat source is specified, the structure has to hold the heat that is already there. A watt you do not lose needs no battery and never runs out.

In this section
  1. TA-01 What is thermal architecture?
  2. TA-02 The microclimate: the air you wear
  3. TA-03 Heat off the skin
  4. TA-04 The five jobs of a thermal system
  5. TA-05 The heat budget
  6. TA-06 Layer order
  7. TA-07 Zones and placement
  8. TA-08 Passive first
  9. TA-09 Control and limits
  10. TA-10 Power architecture
  11. TA-11 An architecture, not a garment
  12. TA-12 Cooling is the same problem, reversed
  13. TA-13 The HEATJAC design rules

What passive means

A passive thermal system has no power source. It works with insulation, still air and surfaces that handle radiant heat. HEATJAC REFLECT is passive in this sense. It returns radiant body heat with a heat-reflective lining and holds warmers in pockets when more is needed.

Passive does not mean weak. In a cold room, a resting person loses most heat by radiation to the cooler walls and equipment. A layer that addresses radiation, with an air gap to let it work, changes the balance without adding a single watt.

Why it comes first even when heat is added

A heated product built on a poor passive structure spends its energy replacing losses. Improve the structure and the same source lasts longer, or a smaller one does the same job. Any heat source we add sits inside the passive structure, never in place of it.

The comparison is easy to run on a bench. Hold the heater power fixed, change only the layers around it, and record the temperature of the air gap. The spread between a good stack and a poor one is larger than most people expect.

The limits of passive

Passive layers return and retain. They cannot create. A person who is producing very little heat, sitting still in deep cold, will eventually need a source. Passive design sets how small that source can be.

The rule in one line

Fix the losses, then size the source for what is left. For the source side, continue to power architecture. For a comparison of the two approaches in use, see passive vs active warming.

Put the lab to work.

Send a brief. A mutual nondisclosure agreement comes first.

Start a program