THERMAL LAB · TA-06 · THERMAL ARCHITECTURE

Layer order

A thermal system is a stack of layers, and the order of the stack decides the direction of the heat. The same three materials can warm a person or warm the outside air, depending only on which one faces the body.

In this section
  1. TA-01 What is thermal architecture?
  2. TA-02 The microclimate: the air you wear
  3. TA-03 Heat off the skin
  4. TA-04 The five jobs of a thermal system
  5. TA-05 The heat budget
  6. TA-06 Layer order
  7. TA-07 Zones and placement
  8. TA-08 Passive first
  9. TA-09 Control and limits
  10. TA-10 Power architecture
  11. TA-11 An architecture, not a garment
  12. TA-12 Cooling is the same problem, reversed
  13. TA-13 The HEATJAC design rules

The stack in a HEATJAC CORE pocket

Counting outward from the base layer, a CORE pocket holds three things.

PositionLayerJob
Closest to the bodyHeat-reflective layerReturns the body's radiant heat toward the body
MiddleInsulation layerSlows heat from the source reaching the skin side
OutermostWarming elementHeats the air under the outer garment

The wearer's own jacket closes the system. It holds the warmed air and is the last barrier before the weather.

Why this order

Heat flows down the path of least resistance. With insulation on the body side of the warming element, the easiest route for its heat is outward, into the air gap under the jacket. That air then warms the whole torso evenly.

The heat-reflective layer does a separate job. It faces the body and sends the body's own infrared heat back. It needs an air space in front of it to work, because a heat-reflective surface pressed flat against another material conducts and stops reflecting.

What happens if the order changes

Put the warming element against the body and the design runs into the contact limit described in heat off the skin. Put the insulation outside the element and the heat is trapped in a small hot zone. Put a heat-reflective layer where it has no air gap and it becomes an expensive piece of fabric.

The general rule

In any stack, decide which direction you want heat to go, then place resistance on the other side. This holds for a garment pocket, a heated battery wrap and an insulated shipping container. Materials for each position are discussed in the materials library.

Put the lab to work.

Send a brief. A mutual nondisclosure agreement comes first.

Start a program