THERMAL LAB · TA-03 · THERMAL ARCHITECTURE

Heat off the skin

Most heated clothing presses a warm element against the body. HEATJAC points its heat away from the skin, into the air under the outer layer. The reason is a limit that every contact heater runs into.

In this section
  1. TA-01 What is thermal architecture?
  2. TA-02 The microclimate: the air you wear
  3. TA-03 Heat off the skin
  4. TA-04 The five jobs of a thermal system
  5. TA-05 The heat budget
  6. TA-06 Layer order
  7. TA-07 Zones and placement
  8. TA-08 Passive first
  9. TA-09 Control and limits
  10. TA-10 Power architecture
  11. TA-11 An architecture, not a garment
  12. TA-12 Cooling is the same problem, reversed
  13. TA-13 The HEATJAC design rules

The contact limit

Skin tolerates only a narrow range of surface temperatures. Discomfort starts in the low 40s °C (around 109 °F), and long contact at temperatures only a little higher can injure skin that looks and feels fine at first. Any heater that touches the body has to stay under that ceiling.

That ceiling caps the power. A small element held at a skin-tolerable temperature can only pass a few watts into the body, and it passes them into one patch. The wearer feels a warm rectangle while the rest of the torso stays cold.

The air has no such limit

Air between the layers can be warmed across the whole torso without any single point on the skin getting hot. The heat reaches the body gently and over a large area, the way a warm room does.

To make that happen, three things have to be true.

  • A layer between the heat source and the body returns the body's own radiant heat and keeps the source off the skin.
  • Insulation sits on the body side of the source, so the easy direction for heat is outward into the air gap.
  • The outer garment is closed enough to hold the warmed air.

What the wearer notices

The warmth feels broad and even, and it arrives without a hot spot. Because the system is warming air that the body would otherwise have to warm itself, the body keeps more of its own heat. Blood flow to the hands and feet has less reason to shut down.

The layer order that makes this work is described in layer order. The surface temperature limits themselves are covered in surface temperature limits.

Put the lab to work.

Send a brief. A mutual nondisclosure agreement comes first.

Start a program