THERMAL LAB · FA-04 · FIELDS

Field and outdoor equipment

Equipment used outdoors meets temperatures its components were never rated for. We help makers of cameras, sensors, drones, robots, instruments and their cases keep the working parts inside their range.

In this section
  1. FA-01 Wearables and protective equipment
  2. FA-02 Medical and care products
  3. FA-03 Batteries and electronics
  4. FA-04 Field and outdoor equipment
  5. FA-05 Defense and public safety
  6. FA-06 Seating, cabins and mobility
  7. FA-07 Cold chain and temperature-sensitive payloads
  8. FA-08 Sleep, shelter and rescue
  9. FA-09 Sports and performance
  10. FA-10 Buildings and personal comfort
  11. FA-11 Products for working animals

The problem

Consumer and industrial components are commonly rated to work from 0 °C (32 °F) or -20 °C (-4 °F). Field use goes well below. In summer, sun on a dark enclosure pushes internal temperatures far above the air. The equipment itself may be the only source of heat, and its battery is the only source of energy.

Typical failures

  • Battery cutoff shortly after start in the cold.
  • Fogged or iced optics.
  • Displays too slow to read.
  • Seals and cables that stiffen and crack.
  • Overheating in a sealed case in the sun.
  • Condensation inside on return to warm air.

Thermal options

NeedOptions
Hold heatInsulation, low-emissivity inner surfaces, minimal thermal bridges
Use waste heatRoute the heat the electronics already make to the battery
Add heatSmall self-regulating heaters at the critical parts
Shed heatHeat spreaders to the case, light-colored or shaded surfaces
Buffer swingsThermal mass or phase change material
Keep dryDesiccant, venting strategy, staged warm-up

What we do

  • Map the temperatures inside an enclosure in cold and in heat.
  • Find the thermal bridges where heat leaks.
  • Compare insulation and heater options at fixed energy.
  • Measure how long the equipment stays in range on its own battery.
  • Recommend changes in order of effect per gram and per watt-hour.

Cases and packs

A carrying case is a thermal product too. An insulated, lightly heated case can keep batteries and instruments ready through a cold day for a few watt-hours. The same architecture as a garment pocket applies: a heat-reflective inner surface, insulation outside the source and a closed air space.

Wearer and equipment together

Equipment carried on the body can share the wearer's warmth. A battery under the outer layer is in a warm place for free. Where a product is worn, we consider the person and the device as one thermal system.

Reading: cold conditions testing and the Knowledge article on batteries in extreme cold.

Put the lab to work.

Send a brief. A mutual nondisclosure agreement comes first.

Start a program