THERMAL LAB · FA-03 · FIELDS

Batteries and electronics

A battery that will not start in the cold has a thermal problem and not an electrical one. We design and test the small thermal systems that keep cells and electronics inside their working range.

In this section
  1. FA-01 Wearables and protective equipment
  2. FA-02 Medical and care products
  3. FA-03 Batteries and electronics
  4. FA-04 Field and outdoor equipment
  5. FA-05 Defense and public safety
  6. FA-06 Seating, cabins and mobility
  7. FA-07 Cold chain and temperature-sensitive payloads
  8. FA-08 Sleep, shelter and rescue
  9. FA-09 Sports and performance
  10. FA-10 Buildings and personal comfort
  11. FA-11 Products for working animals

The problem

Lithium cells lose capacity as they cool and must not be charged below freezing. Displays slow down. Lubricants stiffen. Condensation forms when cold equipment returns to warm air. Equipment that works on a bench fails in a parked vehicle in January.

The usual approach and its limits

A heater pad is attached to the pack and switched by a thermostat. It often works. It also often wastes most of its energy, heats one cell more than its neighbors or takes too long to bring the pack up. The pad was chosen from a catalog and the insulation was an afterthought.

An architectural approach

  • Start with the heat budget. How cold, how long, what target temperature, how much energy can be spared?
  • Insulate first, so the heater's job is small.
  • Spread the heat, so every cell reaches temperature together.
  • Place the sensor where the coldest cell is and not where the heater is.
  • Use self-regulating elements where a hard ceiling is wanted.
  • Decide what powers the heater: the pack itself, external power or both.

What we measure

QuestionMeasurement
How long to reach working temperature from a cold soak?Warm-up curve at multiple points in the pack
Are all cells within a narrow band?Uniformity across the pack
What does preheating cost?Energy in watt-hours
What holds it there?Steady-state power in the cold
Is any surface too hot?Imaging and contact sensing at the heater

Typical programs

  • Evaluation of heater pads and insulation for a battery pack.
  • Thermal design of a small enclosure for electronics used outdoors.
  • Preheat strategy for equipment stored cold and used at short notice.
  • Comparison of heater technologies for a given pack shape.

Scale

Our lab is set up for small systems: packs, enclosures and devices that sit on a bench. For large traction batteries and vehicle-scale thermal management, a specialist automotive facility is the right place.

Reading: lithium cells in the cold, cold is a battery problem too and the Knowledge article how battery pack heaters work.

Put the lab to work.

Send a brief. A mutual nondisclosure agreement comes first.

Start a program