THERMAL LAB · EN-11 · ENGINEERING NOTES
Cold is a battery problem too
Battery heat has an awkward property. As the temperature falls, the heater needs more energy and the battery supplies less. The two curves move against each other, and a design has to account for both.
In this section
- EN-01 Why a heated jacket heats two rectangles
- EN-02 Warm air beats hot pads
- EN-03 The watt is the unit of warmth
- EN-04 What a data sheet does not tell you
- EN-05 Thin is a thermal property
- EN-06 Why we measure in watt-hours
- EN-07 The jacket you already own
- EN-08 The cost of an air leak
- EN-09 Feet and hands follow the core
- EN-10 Heating people, not rooms
- EN-11 Cold is a battery problem too
- EN-12 Why 45 °C is not hot, and why it is
- EN-13 The operating room as a test environment
- EN-14 Designing for the wash
- EN-15 What thermal cameras get wrong
Demand rises
Heat loss grows with the difference between inside and outside. At -10 °C (14 °F) a heater has to work harder than at 5 °C (41 °F) to hold the same warmth. A self-regulating element responds by drawing more power automatically.
Supply falls
A lithium cell delivers less of its capacity as it cools, and less again at high current. At the moment the heater wants more, the battery has less. A pack that lasts five hours on a mild day may last three on a cold one, with no fault in either part.
Three ways to respond
Keep the battery warm. This is the simplest and most effective. A pack carried inside the outer layer, against the body, stays near body temperature. It sees none of the weather.
Reduce the demand. Every watt saved by better insulation and a heat-reflective layer is a watt the battery does not have to find. Passive measures are worth more in the cold than anywhere.
Use a source that ignores the cold. Air-activated warmers work by chemistry that cold storage does not harm. For long, cold, remote use they remain a sound primary source or a reserve.
Starting current
Self-regulating heaters draw their peak current when cold. A cold battery has its highest internal resistance at the same moment. The pack voltage dips, and some packs switch off. The fix is in the system design: staged start-up, a pack kept warm, or wiring sized for the peak.
Charging
Cold cells must not be charged. A product used outdoors should be charged indoors, or carried warm, and its instructions should say so plainly.
Testing for it
A run time measured at room temperature is an upper bound. We repeat run time tests with the system cold-soaked and with the pack in its worn position, and report both figures with their conditions. See cold conditions testing.
The broader pattern
The same squeeze affects every battery device in the cold, including cameras, drones, radios and medical equipment. Keeping the battery in a small warm space is often cheaper than carrying a larger battery.
See lithium cells in the cold and batteries and electronics.