THERMAL LAB · EN-08 · ENGINEERING NOTES
The cost of an air leak
A person in a jacket is surrounded by air their body has paid to warm. Every movement pushes some of it out and draws cold air in. The loss is large, mostly unnoticed, and it sets a limit on any wearable heater.
In this section
- EN-01 Why a heated jacket heats two rectangles
- EN-02 Warm air beats hot pads
- EN-03 The watt is the unit of warmth
- EN-04 What a data sheet does not tell you
- EN-05 Thin is a thermal property
- EN-06 Why we measure in watt-hours
- EN-07 The jacket you already own
- EN-08 The cost of an air leak
- EN-09 Feet and hands follow the core
- EN-10 Heating people, not rooms
- EN-11 Cold is a battery problem too
- EN-12 Why 45 °C is not hot, and why it is
- EN-13 The operating room as a test environment
- EN-14 Designing for the wash
- EN-15 What thermal cameras get wrong
The bellows effect
Walking, reaching and bending change the volume inside clothing. Air leaves at the collar, cuffs, hem and front closure and is replaced from outside. Researchers call this pumping or the bellows effect. Measured clothing insulation on a moving manikin in wind can fall to half of the standing value, and sometimes lower.
What it costs
Warming air takes energy. Air holds about 0.34 Wh per cubic meter for each degree Celsius. Replace the few liters of air inside a jacket many times a minute, with a 20 °C (36 °F) difference between inside and outside, and the loss runs to tens of watts. That is larger than the output of most wearable heaters.
Consequences for heated clothing
A heater in a leaky garment is warming the street. Raising its power raises the loss. The useful steps come first.
- Close the openings. A drawcord hem, a snug collar and closed cuffs matter more than another few watts.
- Wear the heat source inside the layer that seals best.
- Keep the heated air volume small and close to the body.
Why position helps
Air warmed at the torso under a closed jacket has a long way to travel before it escapes. Air warmed by an element in the jacket's outer fabric is next to the exits. Placing the source at the base layer keeps the warm air where it is hardest to pump out.
Where leaks are useful
During hard work the body makes more heat than it needs, and pumping carries the surplus away. Opening a collar is a control. A thermal system should not defeat that. It should make sure the wearer starts warm and can still vent.
How we see it on the bench
A torso form under a jacket, with sensors in the air gap, shows the effect immediately. Open the hem by a hand's width with a little air movement in the room and the gap temperature falls within a minute, with heater power unchanged.
The lesson
Before specifying more heat, find out where the existing heat is going. The answer is often an opening and not a shortage.