THERMAL LAB · EN-01 · ENGINEERING NOTES
Why a heated jacket heats two rectangles
Point a thermal camera at most battery heated jackets and you see two or three warm rectangles on a cold garment. That picture is a consequence of how the product is built, and it explains most of what wearers report.
In this section
- EN-01 Why a heated jacket heats two rectangles
- EN-02 Warm air beats hot pads
- EN-03 The watt is the unit of warmth
- EN-04 What a data sheet does not tell you
- EN-05 Thin is a thermal property
- EN-06 Why we measure in watt-hours
- EN-07 The jacket you already own
- EN-08 The cost of an air leak
- EN-09 Feet and hands follow the core
- EN-10 Heating people, not rooms
- EN-11 Cold is a battery problem too
- EN-12 Why 45 °C is not hot, and why it is
- EN-13 The operating room as a test environment
- EN-14 Designing for the wash
- EN-15 What thermal cameras get wrong
Where the rectangles come from
A heated jacket is a jacket first. The heating elements are added to it, usually one on the back and one on each side of the chest. They are small because the battery is small. A typical pack holds 35 to 50 Wh. Spread over a few hours, that is 7 to 15 W, about a tenth of what the wearer's own body produces at rest.
Ten watts cannot warm a whole garment. So the elements are made small enough to feel distinctly warm to the touch, and the product is judged in a shop by that touch.
Where the heat goes
Each element sits in the jacket, close to the outer fabric, with the cold on the other side. Heat leaves an element in both directions. The share that travels inward crosses the lining, a shirt and an air space before reaching the body. The share that travels outward is gone.
What reaches the wearer arrives at a few patches of skin. The air inside the jacket, which is what actually surrounds the body, is warmed only incidentally.
What wearers describe
A hot spot on the back with cold arms and a cold stomach. Turning the setting up until the patch is too warm, then down again. A battery that is flat by lunchtime on the setting that felt right.
The alternative
The same ten watts used differently behave differently. Placed on the body side of the system, facing outward, behind insulation, the element warms the air between the base layer and the outer layer. The outer garment, whatever it is, then holds that air. The warmth is felt across the torso and there is no patch to overheat.
Add a layer that returns the body's own radiant heat and the ten watts are no longer working alone.
The general point
A heater's wattage tells you what it consumes. It does not tell you what the wearer receives. The architecture around the heater decides that.
For the full comparison, see Why HEATJAC and heat off the skin.