THERMAL LAB · EN-05 · ENGINEERING NOTES
Thin is a thermal property
The best insulation is useless if it stays in the locker. For anything worn under a uniform, thinness is a performance requirement of the same rank as warmth, because it decides whether the product is used.
In this section
- EN-01 Why a heated jacket heats two rectangles
- EN-02 Warm air beats hot pads
- EN-03 The watt is the unit of warmth
- EN-04 What a data sheet does not tell you
- EN-05 Thin is a thermal property
- EN-06 Why we measure in watt-hours
- EN-07 The jacket you already own
- EN-08 The cost of an air leak
- EN-09 Feet and hands follow the core
- EN-10 Heating people, not rooms
- EN-11 Cold is a battery problem too
- EN-12 Why 45 °C is not hot, and why it is
- EN-13 The operating room as a test environment
- EN-14 Designing for the wash
- EN-15 What thermal cameras get wrong
Bulk has a cost
A thick layer under a fitted garment restricts movement, changes how equipment sits and shows. Surgical staff will not wear something that pushes a gown out of place. A police officer's vest has to close. A lineman has to reach overhead. In each case a bulky warm layer loses to being cold.
Thin layers work differently
A thick insulating layer works by resistance alone. A thin system cannot rely on that, so it has to use every other mechanism.
- A heat-reflective surface that deals with radiation and adds almost no thickness.
- A small, well-placed air gap, since still air insulates as well as most foams.
- A heat source facing the right way, so little of its output is wasted.
- The wearer's own outer garment as the main insulating layer.
Thinness forces good architecture. A thick product can afford to be crude.
The air gap
Air between two surfaces resists heat well up to a gap of roughly a centimeter. Beyond that, the air begins to circulate and carry heat across. A few millimeters of trapped air is light, free and effective, provided it stays trapped.
Where thickness still matters
Between the heat source and the skin, some real insulation is needed to turn the heat outward. Our work on thin insulation is about making that layer as thin as possible without losing the effect.
Thin heaters
A thin, flexible heating element allows a belt of the same thickness all the way around. Nothing bulges and nothing presses. It also warms quickly because it has little mass.
The measure
We record thickness as worn, under strap tension, for every configuration we test, alongside its thermal result. A change that gains a degree and adds three millimeters is not automatically an improvement.
The principle
For wearables, performance per millimeter is the figure that matters. A design that ignores it will test well and sell badly.
Related: textiles and carriers.