THERMAL LAB · EN-14 · ENGINEERING NOTES
Designing for the wash
A thermal product that performs on day one and fails after ten washes has failed. Cleaning stresses every thermal material in ways the thermal design never considered, so it has to be designed in from the start.
In this section
- EN-01 Why a heated jacket heats two rectangles
- EN-02 Warm air beats hot pads
- EN-03 The watt is the unit of warmth
- EN-04 What a data sheet does not tell you
- EN-05 Thin is a thermal property
- EN-06 Why we measure in watt-hours
- EN-07 The jacket you already own
- EN-08 The cost of an air leak
- EN-09 Feet and hands follow the core
- EN-10 Heating people, not rooms
- EN-11 Cold is a battery problem too
- EN-12 Why 45 °C is not hot, and why it is
- EN-13 The operating room as a test environment
- EN-14 Designing for the wash
- EN-15 What thermal cameras get wrong
What washing does
| Material | Effect of repeated washing |
|---|---|
| Metallized heat-reflective layers | Metal abrades or oxidizes and emissivity rises |
| Foam insulation | Compression set, loss of thickness |
| Laminates | Adhesive softens and layers separate |
| Heating elements | Flex fatigue at folds and connections |
| Connectors | Corrosion if wet when powered or stored damp |
| Phase change packs | Seals stressed by agitation and heat |
Detergent, heat, agitation and tumble drying each add their own damage. Industrial laundering is harsher than home washing.
Three design strategies
Separate what gets cleaned from what does not. Make the thermal layers removable. The carrier, which touches clothing and collects soil, is washed as a textile. The thermal layers are wiped or left alone.
Protect what cannot be removed. A topcoat over a metallized surface extends its life at some cost in reflectance. Sealed seams keep water out of laminates.
Specify care that matches the materials. Stating hand wash only is better than promising machine washing the materials cannot survive.
Why removable layers are also good thermal design
A pocket that lets a layer be removed also lets it be replaced, upgraded or exchanged for a different function. Removability for cleaning and modularity for performance are the same feature.
Electrical parts
Where a system has electrical parts, they should come out before cleaning. That removes the hardest requirement, washable electronics, and lets heating elements be designed for thermal performance and flex life alone.
Testing
We check thermal performance before and after defined cleaning cycles, using the same side-by-side method as any other comparison. For a heat-reflective material, the image after cleaning is compared with the image before. For a foam, thickness under load is measured before and after.
The clinical case
Healthcare adds its own requirements for cleaning between users and for what may be laundered where. A product for clinical settings needs care instructions that fit the facility's processes.
The principle
Durability is part of the thermal specification. A result that does not survive care is not a result.
See textiles and carriers and the program on heat-reflective surfaces.