THERMAL LAB · ME-13 · METHODS
Reading a thermal report
A thermal report should let a reader who was not in the room understand what was tested, how, and what was found. This page walks through the sections of ours and gives questions worth asking of any report.
In this section
- ME-01 How we test
- ME-02 Method: thermal imaging
- ME-03 Method: contact temperature sensing
- ME-04 Method: power and energy measurement
- ME-05 Method: warm-up curves
- ME-06 Method: steady state and stability
- ME-07 Method: temperature uniformity
- ME-08 Method: side-by-side comparison
- ME-09 Method: cold conditions testing
- ME-10 Method: surface temperature limits
- ME-11 Method: repeatability and uncertainty
- ME-12 Standards we reference
- ME-13 Reading a thermal report
Sections of a report
| Section | Contents |
|---|---|
| Question | What the test was meant to decide |
| Items tested | Description, condition, photographs |
| Setup | Layer stack in order, sensor positions, camera position, power source |
| Conditions | Ambient temperature, air movement, start temperature, duration |
| Record | Graphs of every measured point and area against time, with power |
| Images | Thermal images at stated times, same scale throughout |
| Figures | The numbers that answer the question, with repeatability |
| Findings | Plain statement of what the data shows, and what it does not |
Reading the graphs
Start with the time axis. Find where power was applied and where temperatures settled. Check that the run lasted long enough to settle. Then compare points. The order in which they rise shows the path the heat took.
Reading the images
Check the scale first. A thermal image with a narrow temperature scale makes small differences look dramatic. Two images are comparable only at the same scale. Check what the surface is. A shiny surface in a thermal image is not reliable.
Questions to ask of any report
- Was the electrical input measured, or taken from a label?
- Where exactly were the sensors?
- What was the ambient temperature, and was the air still?
- How long did the run last, and had temperatures settled?
- How many times was it repeated?
- Does the conclusion go further than the test?
What a report is for
A report supports an engineering decision. Choose this element. Change this layer. Size the battery at this many watt-hours. It is not a certificate and should not be presented as one. Where a claim will be made to customers, the report shows what the claim rests on and where an accredited test would be needed to complete it.
Ownership
In a testing program, the client receives the report and the recorded data. Terms are set in writing before work begins. See confidentiality and ownership.
To commission a test, start at the Thermal Lab.