THERMAL LAB · ME-12 · METHODS
Standards we reference
Published standards give thermal claims a common language. This page lists the ones most relevant to our work and what each actually measures. We reference them. Our development testing is not certification to them.
In this section
- ME-01 How we test
- ME-02 Method: thermal imaging
- ME-03 Method: contact temperature sensing
- ME-04 Method: power and energy measurement
- ME-05 Method: warm-up curves
- ME-06 Method: steady state and stability
- ME-07 Method: temperature uniformity
- ME-08 Method: side-by-side comparison
- ME-09 Method: cold conditions testing
- ME-10 Method: surface temperature limits
- ME-11 Method: repeatability and uncertainty
- ME-12 Standards we reference
- ME-13 Reading a thermal report
Materials
| Standard | What it measures |
|---|---|
| ASTM C1371 | Emittance of a surface near room temperature, with a portable emissometer |
| ASTM E408 | Total normal emittance of a surface, by inspection-meter techniques |
| ASTM C518 | Steady-state thermal transmission of flat materials, by heat flow meter |
| ASTM D1518 | Thermal resistance of batting and fabric systems |
Clothing
| Standard | What it measures |
|---|---|
| ASTM F1868, ISO 11092 | Thermal and evaporative resistance of fabrics on a sweating hot plate |
| ASTM F1291, ISO 15831 | Thermal insulation of a whole garment on a heated manikin |
| ASTM F2732 | Temperature ratings for cold weather protective clothing |
| ISO 11079 | Required clothing insulation for cold environments |
| EN 342 | Requirements for garments protecting against cold |
Comfort and contact
| Standard | What it covers |
|---|---|
| ISO 7730, ASHRAE 55 | Thermal comfort of people in indoor environments |
| ISO 13732-1 | Burn thresholds for contact with hot surfaces |
Equipment and environment
| Standard | What it covers |
|---|---|
| MIL-STD-810, Methods 501, 502, 503 | High temperature, low temperature and temperature shock procedures |
| IEC 62133, UN 38.3 | Safety and transport testing of rechargeable lithium cells and batteries |
How we use them
As a reference for method. Where a standard describes a sound procedure for the question at hand, we follow its logic and say where our setup differs.
To read supplier data. A material rating is only meaningful with the standard it was measured under. Emittance under ASTM C1371 and under ASTM E408 are both valid, and they are not interchangeable.
To direct clients. When a product needs a rated figure, such as a garment insulation value, the test belongs in an accredited laboratory with the specified apparatus. We help clients prepare for that test and avoid paying for it twice.
What a standard does not do
A standard defines how to measure. It does not make a product good. A lining with excellent rated emittance can perform poorly in a garment that gives it no air gap. Standards give a fair number. Architecture decides what the number is worth.
Related Knowledge reading: how clothing warmth is tested.